Error #377
tancatNetwork configuration is not really applied after "Saving and applying" settings and a manual reboot is needed to have it working
Descripció
What the subject says :) This has been reported on the mailing lists too.
@Axel Neumann:
In the simple "qMp easy setup" page there is a switch (enabled by
default) which should allow to disable mesh on all ethernet devices.
Disabling that did not work but resulted in a several minutes
unresponsive device untill we rebooted the hard way. Then the switch was
still enabled.
@Juergen:
Settings:
3 Picostation M2 (qMp Clearance 3.2-rc2 ) A B C configured only basic
settingsA and B are meshing
A as gateway B as MP >> B has internet
B as gateway A as MP >> A has no internet
C does not mesh with A nor with C
C as gateway has internet1. C is connected to WAN but status did not show time nor memory.as long
as ESSID was not configured manually in Administration
Actualitzat per Roger Pueyo Centelles fa casi 9 anys
- Estat ha canviat de Nou a En progrés
- % realitzat ha canviat de 0 a 50
See commit 2df4490f358a57a51cf82af723dca592e7f4207b
Actualitzat per Roger Pueyo Centelles fa casi 9 anys
- Estat ha canviat de En progrés a Resolt
- % realitzat ha canviat de 50 a 100
Actualitzat per Roger Pueyo Centelles fa casi 9 anys
- Estat ha canviat de Resolt a Tancat